Controllers Timers

Product Details:

• High speed control: 50 ms input sampling
• Accepts various input: thermocouple, RTD, voltage, or current
• 9 DIs, 9 DOs, and 2 AOs
• Variety of functions: RS-485, T-Link, math function, ramp soak, transmitter power supply, complete templates
• Shallow body and front waterproof structure
• Easy parameter setting thanks to the loader software

Product Details:

• Ambient Temperature And Relative Humidity Surrounding The Controller Must Not Exceed The Maximum Specified Limits.
• The Controller In Its Installed State Must Be Protected Against Excessive Electrostatic Or Electromagnetic Interferences.

• The Controller Must Be Wired As Per Wiring Diagram & It Must Comply With Local Electrical Regulation.
• The Electrical Noise Generated By Switching Inductive Loads Might Create Momentary Fluctuation In Display, Latch Up, Data Loss Or Permanent Damage To The Instrument. To Reduce This Use Snubber Circuit Across The Load.

Product Details:

• Prepare The Cut-out With Proper Dimension As Shown In Figure.
• Remove Clamp From Timer.
• Push The Timer Through Panel Cut-out And Secure The Timer In Its Place By Tightening The Side Clamp.

• Ambient Temperature And Relative Humidity Surrounding The Controller Must Not Exceed The Maximum Specified Limits.
• The Controller In Its Installed State Must Be Protected Against Excessive Electrostatic Or Electromagnetic Interferences.

• The Controller Must Be Wired As Per Wiring Diagram & It Must Comply With Local Electrical Regulation.
• The Electrical Noise Generated By Switching Inductive Loads Might Create Momentary Fluctuation In Display, Latch Up, Data Loss Or Permanent Damage To The Instrument. To Reduce This Use Snubber Circuit Across The Load.

Product Details:

• Ambient Temperature And Relative Humidity Surrounding The Controller Must Not Exceed The Maximum Specified Limits.
• The Controller In Its Installed State Must Be Protected Against Excessive Electrostatic Or Electromagnetic Interferences.

• The Controller Must Be Wired As Per Wiring Diagram & It Must Comply With Local Electrical Regulation.
• The Electrical Noise Generated By Switching Inductive Loads Might Create Momentary Fluctuation In Display, Latch Up, Data Loss Or Permanent Damage To The Instrument. To Reduce This Use Snubber Circuit Across The Load.

Product Details:

• Prepare The Cut-out With Proper Dimension As Shown In Figure.
• Remove Clamp From Timer.
• Push The Timer Through Panel Cut-out And Secure The Timer In Its Place By Tightening The Side Clamp.

• Ambient Temperature And Relative Humidity Surrounding The Controller Must Not Exceed The Maximum Specified Limits.
• The Controller In Its Installed State Must Be Protected Against Excessive Electrostatic Or Electromagnetic Interferences.

• The Controller Must Be Wired As Per Wiring Diagram & It Must Comply With Local Electrical Regulation.
• The Electrical Noise Generated By Switching Inductive Loads Might Create Momentary Fluctuation In Display, Latch Up, Data Loss Or Permanent Damage To The Instrument. To Reduce This Use Snubber Circuit Across The Load.

Product Details:

Product Details: